Safety Functions And Error Display - Gorenje IT624ASC Instructions For Use, Installation, And Connection

Power management for a
limited power cooking
hob (ECO)
Induction plate
Ø (mm)

Safety functions and error display.

ERROR
CODE
r See "Power management for a limited power cooking hob
(ECO)" pag.29
u See "Pan sensor" pag.26
H See "Remaining heat indicator" pag.26
c Induction generator overtemperature
C Induction heater overtemperature
FA Anomaly of infrared signal of the on/off key - all cooking
zones are deactivated
FC On/off button infrared receiver anomaly - all cooking zones
are deactivated
FE Touch control ntc sensor: short circuit on ntc sensor.- all
cooking zones are deactivated
FT Touch control ntc sensor: ntc sensor opening - all cooking
zones are deactivated
Fc Touch control ntc sensor: ntc sensor overheating - all cooking
zones are deactivated
The sequence to finish recording the new cooking hob power limit is :
▪ Simultaneously touch (C of heater 1) and (C of heater 4) keys.
▪ Once this is done, new cooking hob power limit is recorded and there is a
system reset.
To finish without recording the changes:
If there is no action in 60 seconds, changes are not recorded and there is a
system reset
For reduced power consumption, each time the user tries to increase the power, the
total power level of the cooking hob is calculated. If this total power level is greater
than the cooking hob power limit, the power increase is not allowed. An error beep
sounds and the heater display shows the actual power level and an 'r' blinking.
1-3 2-4
210 145
Level Power (W)
0 0 0
1 100 75
2 200 150
3 300 300
4 500 400
5 700 500
6 900 600
7 1100 800
8 1300 1000
9 1500 1200
P 2000 1600
ERROR DESCRIPTION INSTRUCTION MANUAL
Switch the hob off and the oven installed
underneat it until they cool down
completely. Turn on the hob to check all
functions. If the problem remains Contact
authorized center for technical assistance -
specify the error code
Switch the hob off and the oven installed
underneat it until they cool down
completely. Turn on the hob to check all
functions. If the problem remains Contact
authorized center for technical assistance -
specify the error code
Contact authorized center for technical
assistance - specify the error code
Contact authorized center for technical
assistance - specify the error code
Contact authorized center for technical
assistance - specify the error code
Contact authorized center for technical
assistance - specify the error code
Switch the hob off and the oven installed
underneat it until they cool down
completely. Turn on the hob to check all
functions. If the problem remains Contact
authorized center for technical assistance -
29