Mitsubishi Electric PLK-E SERIES Technical Manual page 118

M-080 [Message] TOO LARGE STITCH
M-081 [Message] THERE IS THE SECONT HOME POSITION IN THE PATTERN DATA
M-082 [Message] ILLEGAL SETTING
M-083 [Message] TRIM CODE CAN NOT BE INPUTTED NOR ADDED JUST AFTER
THE NEEDLE DOWN POSITION STOP CODE.
M-084 [Message] NEEDLE DOWN POSITION STOP CODE CAN NOT BE INPUTTED NOR
ADDED JUST BEFORE THE TRIM CODE.
M-085 [Message] NEEDLE POSITION IS DEVIATED FROM THE NEEDLE COORDINATES
. CAN NOT OPERATE.
M-086 [Message] NEEDLE POSITION IS DEVIATED FROM THE NEEDLE COORDINATES.
CAN NOT OPERATE.
M-100 [Message] NOW MAKING DATA
M-101 [Message] CALCULATING...
M-102 [Message] MAKE ARC DATA?
M-103 [Message] MAKE CIRCLE DATA?
M-104 [Message] MAKE CURVE DATA?
M-105 [Message] MAKE BREAK LINE DATA?
M-106 [Message] MOVE TO END DATA
M-120 [Message] MOVE TO START POINT
M-121 [Message] MOVE TO STARTING POSITION
M-122 [Message] A SPECIFIED POSITION IS WRONG
M-123 [Message] THE AMOUNT OF THE MOVEMENT IS NOT INPUT
M-124 [Message] A SPECIFIED POSITION IS WRONG
M-125 [Message] A SPECIFIED POSITION IS WRONG
M-126 [Message] A SPECIFIED POSITION IS WRONG
[Sub Message] PLEASE CHANGE THE PATTERN DATA
[Sub Message] PLEASE RETURN TO HOME POSITION
[Sub Message] PLEASE INPUT A CORRECT VALUE
[Sub Message]
[Sub Message]
[Sub Message] PLEASE RETURN TO HOME POSITION
[Sub Message] PLEASE RETURN TO HOME POSITION
[Sub Message] PLEASE WAIT FOR A WHILE
[Sub Message] PLEASE WAIT FOR A WHILE
[Sub Message] PLEASE WAIT FOR A WHILE
[Sub Message] PLEASE WAIT FOR A WHILE
[Sub Message] PLEASE WAIT FOR A WHILE
[Sub Message] PLEASE SPECIFY FOLLOWING STITCH FROM START POINT
[Sub Message] PLEASE INPUT AMOUNT OF MOVEMENT
[Sub Message] PLEASE SPECIFY SEWING DATA
[Sub Message] PLEASE SPECIFY SEWING AND FEED DATA
[Sub Message] PLEASE SPECIFY ONE STITCH FRONT IS SEW OR FEED DATA
116