Table of Contents
Advertisement
M-204
*.The specified pattern number could not be found during reading of the pattern from
the floppy disk.
[Message] PATTERN DATA ON FLOPPY DISK IS NOT FOUND
M-205
[Message] FLOPPY DISK FORMATTING..............
M-206
[Message] FLOPPY DISK FORMAT FINISH
M-207
[Message] PATTERN DATA IS WRITTEN ON FLOPPY DISK
M-208
[Message] PATTERN DATA OF FLOPPY DISK IS BEING DELETED
M-209
[Message] PATTERN DATA READING TO FLOPPY DISK.....
M-210
[Message] PATTETRN DATA OVER WRITE TO FLOPPY DISK ?
M-211
[Message] PATTERN DATA DELETE FROM FLOPPY DISK ?
M-212
[Message] CAN THE AMOUNT OF THE HOME CORRECTION BE CONVERTED INTO
THE PATTERN DATA AND ADD ?
M-213
[Message] THERE IS NO PERTINENT FILE IN THE FLOPPY DISK.
M-220
*.Write in to internal memory is prohibited.
[Message] MEMORY IS WRITE PROTECTED
M-221
*. An error has occurred in the internal memory.
[Message] MEMORY ERROR
M-222
*.There is a shortage of internal memory empty area.
[Message] MEMORY IS PATTERN DATA FULL
M-223
*.The specified patter number was not found during reading of the pattern from
the internal memory.
[Message] PATTERN DATA ON MEMORY IS NOT FOUND
M-224
[Message] MEMORY FORMATTING..................
M-225
[Message] MEMORY FORMAT END
M-226
[Message] PARTITION No. OF MEMORY IS ILLEGAL
M-227
[Message] PATTERN DATA WRITING TO MEMORY.....
*.Confirm the specified pattern number and execute read in again.
[Sub Message] PLEASE CONFIRM THE FILE NAME AND THE SEWING DATA NUMBER.
[Sub Message] PLEASE WAIT FOR A WHILE
[Sub Message] PLEASE WAIT FOR A WHILE
[Sub Message] PLEASE WAIT FOR A WHILE
[Sub Message] PLEASE WAIT FOR A WHILE
[Sub Message] FORMER DATA IS DELETED WHEN OVERWRITING.
[Sub Message] PLEASE WAIT FOR A WHILE
[Sub Message] RETURN TO HOME POSITION AFTER WRITING ENDS.
[Sub Message] PLEASE CONFIRM THE FILE OF THE FLOPPY DISK.
*.Change the [on] setting of [A] mode [internal memory write in prohibit (PFL.)]
function to [of].
[Sub Message] PLEASE RELEASE WRITE-PROTECTION WHEN WRITING.
*.Return to [normal mode] by turning [on] the [C] key Execute the same operation again. If
message code [M-11] is displayed again, copy the other parts of the internal memory onto
a floppy disk and reformat the internal memory.
[Sub Message] PLEASE FORMAT AN INTERNAL MEMORY.
*.Delete unnecessary patterns or change [A] mode [sewing data No. of divisions
setting ]FLB.)].
[Sub Message] PLEASE DELETE THE SEWING DATA NOT USED.
*.Confirm the specified pattern number and execute reading again.
[Sub Message] PLEASE CONFIRM THE FILE NAME AND THE SEWING DATA NUMBER.
[Sub Message] PLEASE WAIT FOR A WHILE
[Sub Message] PLEASE WAIT FOR A WHILE
[Sub Message] PLEASE WAIT FOR A WHILE
118
Hide quick links:
Advertisement
Table of Contents
