Download  Print this page

Error Codes - Mitsubishi Electric PLK-E SERIES Technical Manual

Programmable sewing machine.
Hide thumbs

Advertisement

3.[M-**] message code (Restoration possible)
*. When the control board presses the confirmation, the message code number lights to display panel of a set panel and the explanation is displayed in the liquid crystal panel. (The buzzer) rings intermittent.
*.When an [error code No.] is displayed, confirm the [message code No.] and investigate according to the following table.
*.The machine can be restored to [normal mode] by turning [on] the [C] key after confirming the content of the [message code].
Error Code
(Display)
M-001
*.The sewing machine has stopped at a stop position away from the normal UP stop position.
(Away by more than [+20 degrees] due to the sewing machine pulley.)
[Message] NEEDLE NOT UP POSITION
M-002
*.The needle thread trimming detection input signal (THS) has been input [ON].
[Message] NEEDLE THREAD BROKEN
M-003
*.The presser foot is rising [OFF].
[Message] CLUMP UP POSITION
M-004
*.The production number ((UP) counter) has reached the set value.
[Message] UP COUNTER SETTING VALUE UP
M-005
*.(DOWN)counter has reached the set value.
[Message] DOWN COUNTER SETTING VALUE UP
M-006
*.There is no sewing data in the current data area of the internal memory.
[Message] PATTERN DATA NOTHING
M-007
[Message] NOT HOME POSITION CAN'T OPERATE
M-008
[Message] SERIAL DATA TRANSMITTING...(RS232C)
M-009
[Message] SERIAL DATA RECEIVING...(RS232C)
M-010
[Message] HALT SW IS PRESSED
M-011
[Message] PLEASE RUN SEWING MACHINE
SEWING
M-012
[Message] HALT SW IS PRESSED POWER ON
M-013
[Message] NOW KEY LOCK
M-014
[Message] FUNCTION PROHIBITION SETTING (UCC) OF PRESENT VALUE IS ON
Message(state etc.)
113
Sub-message (corresponding method etc.)
*.When the [C] key is turned [ON], the needle rotates in the forward direction and stops at
the normal UP stop position.
[Sub Message] MAKE THE NEEDLE A UP POSITION
*.Thread the needle thread and turn [ON] the [C] key.
[Sub Message] PLEASE PASS THE UPPER THREAD THROUGH THE NEEDLE
*.Lower [ON] the presser foot.
[Sub Message] TURN ON THE FOOT SWITCH (BLACK FOOT SWITCH)
*.Turn [ON] the [C] key (enter key) and cancel.
[Sub Message]
*.Turn [ON] the [C] key (enter key) and cancel.
[Sub Message]
*.Turn [ON] the [C] key, and after turn [ON] the [D] key and read the pattern.
[Sub Message] READING OR TEACHING INPUT
*.Turn [ON] the [H] key (return key).
[Sub Message] PRESS HOME KEY
[Sub Message] PLEASE WAIT FOR A WHILE
[Sub Message] PLEASE WAIT FOR A WHILE
[Sub Message] PLEASE ROTATE THE HALT SWITCH RIGHT AND TURN OFF
[Sub Message] PLEASE ROTATE THE SEWING MACHINE BY THE WINDER OR
[Sub Message] PLEASE TURN OFF THE POWER SUPPLY
[Sub Message] PLEASE TURN OFF SETTING (UCC) WHEN CORRECTING.

Advertisement

Table of Contents

   Related Manuals for Mitsubishi Electric PLK-E SERIES

Comments to this Manuals

Symbols: 0
Latest comments: