Mitsubishi Electric PLK-E SERIES Technical Manual page 119

M-127 [Message] A SPECIFIED POSITION IS WRONG
M-128 [Message] A SPECIFIED POSITION IS WRONG
M-129 [Message] THE SPECIFIED CODE CANNOT BE DELETED.
M-130 [Message] CAN'T FIND SEWING DATA
M-140 [Message] CAN'T FIND OFFSET DATA
M-141 [Message] CAN'T FIND OVERLAP DATA
M-142 [Message] TOO SMALL REDUCTION RATIO
M-143 [Message] TOO LARGE ENLARGEMENT RATIO
M-144 [Message] THE POINT INPUT DATA CANNOT BE CONVERTED.
M-145 [Message] THE POSITION OF START TACKING CANNOT BE CONVERTED
BECAUSE OF THE POINT INPUT DATA.
M-146 [Message] THE POSITION OF END TACKING CANNOT BE CONVERTED
BECAUSE OF THE POINT INPUT DATA.
M-160 [Message] PLEASE MAKE AREA LIMIT EFFECTIVE
M-161 [Message] HALT SW IS PRESSED
M-162 [Message] ILLEGAL NUMBER WAS SET
M-163 [Message] THE DATA IS BEING CONVERTED INTO A NEW VERSION.
M-200 *.FD is not insert to FDD.
*.System software is broken into built in memory.
[Message] FLOPPY DISK ISN'T IN FLOPPY DISK DRIVE
M-201 *.The floppy disk is write protected.
[Message] FLOPPY DISK IS WRITE PROTECTED
M-202 *.There is an error in the floppy disk.
[Message] FLOPPY DISK ERROR
M-203 *. There is a shortage of empty area in the disk.
[Message] AN EMPTY AREA ON FLOPPY DISK IS INSUFFICIENT
[Sub Message] PLEASE SPECIFY PREVIOUS DATA FROM FINAL STITCH
[Sub Message] PLEASE SPECIFY CODE DATA
[Sub Message] THE TRIM CODE CANNOT BE DELETE WHEN THE FORWARD ARE
SEW OR THE BACK ARE FEED.
[Sub Message] THIS FUNCTION CANNOT BE USED
[Sub Message] THE OFFSET DATA TRANSFORM FUNCTION CANNOT BE USED
[Sub Message] THE MULTIPLE DATA TRANSFORM FUNCTION CANNOT BE USED
[Sub Message] PLEASE DO A CORRECT SETTING
[Sub Message] PLEASE DO A CORRECT SETTING
[Sub Message] PLEASE SPECIFY SEWING DATA OTHER THAN THE POINT INPUT.
[Sub Message] PLEASE SPECIFY SEWING DATA OTHER THAN THE POINT INPUT.
[Sub Message] PLEASE SPECIFY SEWING DATA OTHER THAN THE POINT INPUT.
[Sub Message] IT IS DANGEROUS WHEN USING BY THE AREA LIMIT RELEASE
[Sub Message] PLEASE RELEASE THE HALT SWITCH
[Sub Message] PLEASE SETTING AGAIN
[Sub Message] PLEASE WAIT FOR A WHILE
*. Confirm the floppy disk set in.
*.Read the system software.
[Sub Message] PLEASE INSERT THE FLOPPY DISK.
*.Confirm the floppy disk and cancel the unlock the write protection ore use another floppy
disk.
[Sub Message] PLEASE RELEASE THE WRITE-PROTECTION OF THE FLOPPY DISK.
*.Use a new floppy disk.
[Sub Message] PLEASE EXCHANGE THE FLOPPY DISK OR FORMAT.
*.Check the floppy disk.
[Sub Message] PLEASE EXCHANGE THE FLOPPY DISK OR DELETE THE FILE.
117