Mitsubishi Electric PLK-E SERIES Technical Manual page 117

M-058 [Message] TOO SMALL STITCH
M-059 [Message] TOO LARGE STITCH
M-060 [Message] ALREADY SET SECOND HOME
M-061 [Message] DATA WRITING TO MEMORY.....
M-062 [Message] TOO LARGE FEED STITCH
M-063 [Message] NUMBER OF SKIP JOG IS TOO FEW OR IT IS TOO MANY
M-064 [Message] IT WAS NOT POSSIBLE TO OPERATE
M-065 [Message] PRESS HOME KEY
M-066 [Message] DATA TYPE IS DIFFERENT
M-067 [Message] CURVE DATA WAS NOT ABLE TO BE MADE
M-068 [Message] IT IS DURING THE IMAGE DISPLAY PREPARATION.....
M-069 [Message] THERE IS THE SECONT HOME POSITION IN THE PATTERN DATA
M-070 [Message] CURVE DATA WAS NOT ABLE TO BE MADE FROM INPUT POINT
OR AN OFFSET/MULTIPLE POINT
M-071 [Message] THERE IS NO DELETED DATA.
M-072 [Message] THE TR IS NOT INPUT AND CANNOT BE ADDED TO THIS POSITION.
M-073 [Message] THE SAME CODE AS THE DATA JUST BEFORE IS NOT INPUT OR
CANNOT BE ADDED.
M-074 [Message] THE 2HP IS NOT INPUT AND CANNOT BE ADDED TO THIS POSITION.
M-075 [Message] THE END IS NOT INPUT AND CANNOT BE ADDED TO THIS POSITION.
M-076 [Message] THE CIRCLE OR THE ARC WAS NOT MADE FROM THE INPUT POINT.
M-077 [Message]THE MULTIPLE BACK TAKING CANNOT BE SPECIFIED.
M-078 [Message] PLEASE PUSH THE HOME KEY. AFTER RETURNING TO HOME POSITION.
M-079 [Message] PLEASE PUSH THE HOME KEY. AFTER RETURNING TO HOME POSITION.
[Sub Message] PLEASE INPUT THE VALUE WITHIN THE RANGE
[Sub Message] PLEASE INPUT THE VALUE WITHIN THE RANGE
[Sub Message] ONLY ONE SECOND HOME POSITION POINT CAN BE INPUT
[Sub Message] PLEASE WAIT FOR A WHILE
[Sub Message] PLEASE SET FEED WITHIN 0.1-12.0mm
[Sub Message] PLEASE INPUT THE VALUE WITHIN THE RANGE
[Sub Message] PLEASE DECREASE INPUT POINT AND INPUT AGAIN
[Sub Message] PLEASE CONFIRM DATA TYPE
[Sub Message] PLEASE INPUT AGAIN REFERRING TO CURVE INPUT NOTES
[Sub Message] PLEASE WAIT FOR A WHILE
[Sub Message] PLEASE RETURN TO HOME POSITION
[Sub Message] PLEASE REVIEW INPUT POINT
[Sub Message] PLEASE INPUT AND ADD THE TRIM
[Sub Message] PLEASE INPUT AND ADD THE 2HP AFTER FEED
[Sub Message] PLEASE INPUT AND ADD THE END AFTER FEED OR TRIM
[Sub Message] PLEASE REVIEW INPUT POINT
[Sub Message]THE MULTIPLE BACK TAKING CAN BE USED ONLY FOR THE FIGURE
WHERE CIRCLE, CURVE, AND BROKEN LINE SHUT.
[Sub Message] PLEASE WAIT FOR A WHILE AFTER PUSHING THE HOME KEY.
[Sub Message] PLEASE WAIT FOR A WHILE AFTER PUSHING THE HOME KEY.
115
AFTER SEW