Table of Contents
Advertisement
NEXT SCREEN LOOKS LIKE THIS
NEXT SCREEN LOOKS LIKE THIS
NEXT SCREEN LOOKS LIKE THIS
11. PRESS THE FEED KEY
12. USING THE ARROW KEYS, FEED
X +40MM TO POINT 3
NOTE 1: THE MACHINE WILL AUTOMATICALLY
TRIM THE THREAD AT POINT 2
13. PRESS THE ENTER KEY
NOTE 2: IF YOU WANT THE CLAMP TO
RAISE AFTER THIS STEP, YOU WOULD
PRESS THE CODE KEY AND ENTER THE
USTP CODE (UP STOP) AND THEN CONTINUE
TO THE NEXT STEP
14. USING THE ARROW KEYS, MOVE
Y +40MM TO POINT 4
15. PRESS THE ENTER KEY
73
Hide quick links:
Advertisement
Table of Contents
