LED mark
PWR2
RPS status LED
The S5150X-16ST-EI switch supports RPS input. The RPS status LED shows the status of the RPS
input.
Table 23 RPS status LED description
LED mark
RPS
Port mode LED
To show more information about the switch through the port status LEDs, the S5150-24S-PWR-EI
switch provides a port mode LED. The port mode LED indicates the type of information that the
network port LEDs are showing.
Table 24 Port mode LED description
LED mark
Mode
Management Ethernet port LEDs
The S5150X-16S-EI and S5150X-16ST-EI switches provide a management Ethernet port LED to
indicate the operating state of the management Ethernet port.
Table 25 Management Ethernet port LED description
Management Ethernet port LED
(MGMT) status
Steady green
Flashing green
Status
Steady green
Steady yellow
Off
Status
Steady green
Steady yellow
Off
Status
Steady green
Flashing green
Flashing yellow
Description
A power module is installed in power module slot 2, and the power
module is outputting power correctly.
A power module is installed in power module slot 2, but the power
module has failed or no power is input to the power module.
No power module is installed in power module slot 2.
Description
Both the RPS DC input and the AC input are normal.
The RPS DC input is normal, but the AC input is disconnected or
has failed.
The RPS DC input is abnormal or no RPS is connected.
Description
The port status LEDs are showing port rates.
The port status LEDs are showing the status of PoE power supply
on the ports.
The port status LEDs indicate the IRF member ID of the switch.
For example, if the LEDs for ports 1 to 5 are steady green and the
other LEDs are off, the IRF member ID of the switch is 5.
Description
A link is present on the port and the port is operating at 1000
Mbps.
The port is sending or receiving data at 1000 Mbps.
55