Fitting Unit; Air Inlet Hose; Locking Clamp Screw Clamp And Insulation - Rinnai RHFE-556FTD How To Use Manual

FITTING UNIT
AIR INLET HOSE
Detail of Hose clip
Plastic tie
Inlet hose
LOCKING CLAMP SCREW CLAMP AND
INSULATION.
The following components can be fitted by
reaching down the rear of the appliance as it is
positioned against the wail.
1. Connect the flue outlet to the manifold by
extending the stainless steel sliding tube until it
is fully inserted into the manifold.
I, /
. .*
,*
ManiloM
Sliding Tub
Do not extend flue tube
beyond red line.
2. Fit the locking clamp over connection
between sliding tube and manifold. Engage the
hook and rotate it until it snaps against the
body of the clamp.
flue ou
Sliding
Manifold
P
Lo&g
damp
3. ,Fit the screw clamp between the sliding tube
and the flue elbow.' Secure with the 4 mm screw
supplied. The flue outlet is now locked into
position.
I I
saew
Locking damp
I
I
Flue Outlet tube
I I- I
w
Manifold
4. Slide the insulation sleeve up to the flue
manifold, slip the securing clip over the sleeve
as shown.
I
Fit clip
I
A
Ftueelbow '
-2l-