Room Temperature Adjustment; Fan Filter - Rinnai RHFE-556FTD How To Use Manual

1 n
ROOM TEMPERATURE ADJUSTMENT
I
he room temperature and pre-set temperatures can only be displayed and adjusted when
the heater is running.
ON/OFF Button
n
1'1
Press the "A" button to increase the temperature
setting
or "V" button to decrease the temperature
setting.
The Temperatures can be preset to:
a) [ L ] low (about
1O'C)
b) [16"C] to [26'C] in 2' C steps
c) [ H ] (continuously high)
Selected Room
Temperature Display
l
Temperature Adjustment Buttons
* Flashing LED is room temperature.
Steady LED is selected temperature.
.
If the heater does not ignite then the pre-set temperature may not be set to, a setting which is
higher than the room temperature. The ON indicator will change colour from red to green
when the heater reaches the pre-set temperature and stops running. The heater will operate at
eight minute intervals to maintain warmth in a room.
n
FAN FILTER
To protect the room air fan from dust particles or
lint, a filter is situated at the rear of the appliance.
When this filter becomes blocked, the filter
indicator will flash to indicate that it should be
cleaned. Clean the filter weekly during the heating
season to avoid unnecessary strain on the
appliance.
Do not remove filter when appliance is
operating. When the filter requires cleaning,
clean filter before using the appliance, or whilst
the appliance is not operating.
If you do not clean the filter at regular intervals
and the filier indicator is allowed to remain
flashing, then the appliance will stop and [201 will
flash on the Digital Display signifying that the
inbuilt safety device has functioned. You must
clean the filter before operating the heater again.
-lO-