Rinnai RHFE-556FTD How To Use Manual page 20

SLEEVE AND
NIFOLD INSTALLATION
METHOD FOR STANDARD WALLS
Terminal sad
5. Check rubber seal is in place on terminal.
(Add
Vteattw
board'
l
For weather board walls, add spare
rubber seal provided to compensate for
weatherboard angle.
6.
Installation of Terminal
_', '.
From outside, insert terminal into sleeve
with the "A" mark at the top. Left hand
side fixing tie is marked "LEFT" (from
inside).
7.
Attaching Ties
Pull hard on left and right hand side ties,
clip ties over lugs inside sleeve. You
should be able to pull ties 2 or 3 slots
past the starting point. Cut the ties,
leaving about 20 mm past the lugs. Bend
ties so they are parallel with the wall.
erminal
8.
Insert Inner Connection Assembly. Push
assembly into the terminal tube, make
sure "TOP" mark is uppermost. Fix with 3
screws provided.
-,' /
. .'
,I
9.
Manifold can still be turned after
attaching.
-2o-