Siemens TE502 series Instruction Manual page 39

Descaling
Duration: approx� 25 minutes�
Important: If there is a filter in the water
tank (16), it needs to be removed before the
descaling programme is run�
If the message
Descale required!
on the display, press the
(12) for 3 seconds and then press the start
button (10)� The descaling programme will
start�
To descale the appliance before being
prompted, press the
at least 3 seconds� Then press the
button (12) briefly twice. Turn the upper
rotary knob (14) until
appears in the display�
To start the descaling procedure, press the
start button (10)�
The display will guide you through the
programme�
Empty drip tray
Insert drip tray
● Empty drip tray (8) and replace them�
N.B.: If the water filter is activated, the
display will prompt you to remove the filter
and then press the start button (10) again�
Remove the filter now if you have not
already done so� Press the start button (10)�
Fill descaler
Press start
● Pour lukewarm water into the empty
water tank (16) up to the 0.5 l mark
and then dissolve 1 Siemens descaling
tablet TZ80002 in it� When using
TZ60002, 2 tablets must be dissolved�
● Press the start button (10)�
Descale in progress
The descaling pro gramme will now run for
about 10 minutes�
appears
e
j
off / button
e
j
off / button (12) for
e
off /
Start descaling
Place container
Pull milk frother
● Place a receptacle with a capacity of at
least 0�5 litres under the outlet�
● Pull the milk frother (6) to open it�
Descale in progress
The descaling pro gramme will now run for
about 12 minutes�
Clean / Fill water tank
Press start
● Rinse the water tank (16) and refill it
with fresh water up to the max mark�
j
● Press the start button (10)�
Descale in progress
The descaling pro gramme now runs for
about 30 seconds and rinses the appliance�
Push milk frother
● Push the milk frother (6) in to close it�
Descale in progress
The descaling pro gramme now runs for
about 1 minute�
Empty drip tray
Insert drip tray
● Empty drip tray (8) and replace them�
Replace the filter if one is being used. The
appliance has completed descaling and is
ready for use again�
Important: Wipe down the appliance using
a soft, damp cloth to immediately remove
any descaler residue� Such residue can
cause corrosion� New sponge cloths may
contain salts. Salts can cause rust film
on stainless steel and must therefore be
washed out thoroughly before use�
en
35