Water Filter - Siemens TE502 series Instruction Manual

13� Carefully pull out the milk frother (6) to
open it� The appliance rinses out the
milk frother (6) with water� The display
shows
Push milk frother
14� Push the milk frother (6) in to close it�
The appliance heats up and rinses� Some
water will run out of the coffee outlet�
When the drink selection menu is shown in
the display, the appliance is ready for use�
Switching off the appliance
The factory settings of the fully automatic
espresso machine are programmed for
optimal performance� The appliance
switches off automatically after a specific
time (time span can be programmed, see
"Menu settings"
Shut off
Exception: The appliance switches off
without rinsing if only hot water or steam
were dispensed�
To switch the appliance off manually before
e
this, press the off /
appliance rinses and switches off�
N.B.: If the appliance is being used for the
first time, a service program has been run,
or the appliance has not been operated
for a long period, the first beverage will
not have the full aroma and should not be
consumed�
When using the espresso machine for the
first time, you will achieve a suitably thick
and stable "crema" only after the first few
cups have been dispensed�
After extended use, water droplets may
form on the ventilation slots� This is normal�
�
)�
j
button (12)� The

Water filter

A water filter can prevent scale buildup.
Before a new water filter is used, it must be
rinsed� To do this, proceed as follows:
1� Press the water filter firmly into the
water tank with the aid of the measuring
spoon (18)�
2� Fill the water tank (16) with water up to
the max mark�
3� Press and hold the
for at least three seconds� The menu
opens�
e
4� Press the off /
repeatedly until the display shows
No / Old filter
5� Select
Activate filter
rotary knob (14)�
6� Press the start button (10)�
7� Place a receptacle with a capacity of
0�5 litres under the outlet�
8� Press the start button (10)�
9� Pull the milk frother (6) to open it�
10� Water will now flow through the filter to
rinse it�
11� Push the milk frother (6) in to close it�
12� Empty the container�
The appliance is ready to use once more�
Note: Rinsing the filter simultaneously
activates the setting for the
display�
e
j
off / button (12)
j
button (12)
�
with the upper
Change filter!
en
27