Replacing Your Steam Locomotive's Lamps - Lionel 4-6-9 Camelback Owner's Manual

Maintaining your locomotive

Replacing your steam locomotive's lamps

Y our steam locomotive is illuminated by
two lamps, one is located directly behind
the boilerface, the other is behind the motor
for the firebox glow. During the course of
normal operation, the lamps may require
replacement.
Carefully remove the four cab screws (see
page 8 for location) then gently unplug the 4
handrails from the pilot. Carefully lift the
shell away from the frame. Take care with
the various wiring assemblies con-
nected to the shell. Find the assembly
containing the expired lamp. The
front lamp is removed by unplugging
the connector on the wire harness,
then carefully pulling the bulb from
the bottom of the headlight housing.
The bulb can then be fed through the
hole in the boiler front and replaced.
Replace it with Lionel part No. 610-
8089-136. The firebox lamp is
Your steam tender marker back-up light is
illuminated by one lamp located in the rear
of the tender body. During the course of nor-
mal operation, the lamp may require
replacement.
Carefully remove the four body screws
located on the four corners of the frame.
Carefully lift the shell away from the frame.
Find the expired lamp. Remove the bulb by
unplugging the wire harness at the connec-
tors, then gently untaping the wires, and
pulling the bulb from its housing. Replace it
with Lionel part No. 610-8089-156. The lamp
is available from your Authorized Lionel
Service Center or Lionel Service. See the
Lionel Service section on page 24 for more
information. Reinstall the tender body and
replaced by lifting the bulb up out of the
mounting sockets, replace it with Lionel part
No. 610-8082-019. The marker lamps are
LED's and should not normally require
replacement. Lamps are available from your
Authorized Lionel Service Center or Lionel
Service. See the Lionel Service section on
page 24 for more information. Reinstall the
cab and the four screws taking care to not
pinch any wires during reassembly.
the four screws taking care to not pinch any
wires during reassembly.
Lionel part
No. 610-8089-156
NOTE: For command or upgraded engines,
press Aux2 to make sure headlamp was not
accidently turned off, before replacing bulb.
9
Lionel part
No. 610-8089-136
Lionel part
No. 610-8082-019