Replacing Your Locomotive's Lamps - Lionel AMERICAN FLYER EP-5 Owner's Manual

Maintaining and servicing your locomotive

Replacing your locomotive's lamps

Y
our locomotive is illuminated by two lamps, Lionel part no. 640-8075-330. During
the course of normal operations, you may find that these lamps require replacement.
Replacement lamps are available from your authorized Lionel Service Center or from Lionel
Service.
To replace the lamps, remove the four body screws from the underside of the frame and lift
away the body. Refer to Figure 4 on page 9 for the location of these screws. Remove the two
screws holding the light retainer to the body. Carefully pull the expired lamp out of the holder.
Follow the wires back to the circuit board and unplug the connector from the board. Plug in
the replacement lamp, then position the new lamp in the holder. Reposition the light retainer
and secure in place with the two screws. Place the body back on the frame, being careful not
to pinch any of the wires and secure together with the four screws removed earlier to complete
the lamp replacement.
FRONT
Figure 5. Lamp replacement
Inside the b­ody
10
Light retainer
Holder
Lionel part no.
640-8075-300