Table of Contents
Advertisement
Maintaining your locomotive
Adding fluid to your Locomotive's smoke generator
Y
our Locomotive is equipped with a
smoke generator that produces safe,
clean white smoke during operation.
The smoke generator requires the periodic
addition of Lionel smoke fluid in order to
function. Pierce the tube end with a pin, then
add four to eight drops of fluid directly into
the Locomotive's stack. Smoke production
will commence momentarily, faster if you
run your Locomotive at speed. When smoke
production wanes, add more fluid (four to
eight drops).
If you prefer to have a smoke free locomo-
tive, there is a switch located on the bottom of
the engine under the cab marked SMOKE ON
Available Railsounds and Command Control Upgrades
T
o experience the most from your locomotive
several upgrade options are available,
including Railsounds, Command Control, and
Electrocoupler. With these you can enjoy the
full spectrum of digitally recorded real steam
locomotive sounds and the ability to control
your locomotive from anywhere. As with all
OFF (see page 6 for location). Move the switch
to off and your locomotive will stop smoking.
If you have installed the Command Con-
trol upgrade you can use the feature below to
increase smoke production. An idle Loco-
motive will not smoke; press AUX1 and 9
(press for a maximum of 10 seconds) to
engage the smoke generator at idle/in neu-
tral. When the smoke unit is on Always
keep a small amount of smoke fluid in the
Locomotive's smoke generator; the genera-
tor's element can become damaged if operat-
ed without fluid. Smoke production is greater
at higher voltages and when the locomotive
is pulling a heavy load or long consist.
upgrades you may choose to have this done at
an authorized Lionel Service Center for a fee, or
you can choose to "do it yourself". Just fol-
low these instructions we have included and
you'll be ready to experience the fun that is
today's Lionel.
10
Hide quick links:
Advertisement
Table of Contents
