Lenovo ThinkPad T560 User Manual page 83

Indicator behavior of the fingerprint reader
Indicator behavior
Green
Amber
Associating your fingerprints with your power-on password and hard disk password
To associate your fingerprints with your power-on password and hard disk password, do the following:
1. Turn off and then turn on the computer.
2. When prompted, swipe your finger over the fingerprint reader.
3. Enter your power-on password, hard disk password, or both as required. The connection is created.
When you start the computer again, you can use your fingerprints to log in to the computer with no need to
enter your Windows password, power-on password, and hard disk password.
Attention: If you always use your fingerprint to log in to the computer, you might forget your passwords.
Write down your passwords, and keep them in a safe place. If you forget your power-on password, you must
take your computer to a Lenovo authorized servicer or a marketing representative to have the password
canceled. If you forget your hard disk password, Lenovo cannot reset your password or recover data from
the storage drive. You must take your computer to a Lenovo authorized servicer or a marketing representative
to have the drive replaced. Proof of purchase is required, and a fee will be charged for parts and service.
Setting the fingerprint reader
You can set the fingerprint reader in the Fingerprint Manager Pro program. You also can change some
advanced settings in the ThinkPad Setup program.
To change the settings in the Fingerprint Manager Pro program, click Settings on the program main interface.
To change the settings in the ThinkPad Setup program, see "Using the ThinkPad Setup program" on page 73.
You can set the following configurations in the ThinkPad Setup program:
• Predesktop Authentication: Enables or disables fingerprint authentication before the operating system
is loaded.
• Reader Priority: Defines the priority for the fingerprint readers if an external fingerprint reader is attached.
• Security Mode: Specifies the settings of the security mode.
Description
The fingerprint reader is ready for swiping.
The fingerprint cannot be authenticated.
67
.
Chapter 5 Security