Gamma Progression STII Owner's Manual page 5

ASSEMBLY INSTRUCTIONS
Clamp Head Installation
The post of the string clamp head and tube
of the string clamp base are treated with
grease to provide protection against corro-
sion during shipping. Remove any exces-
sive grease with a clean cloth prior to use.
The post and tube may also be cleaned with
isopropyl alcohol. After this type of thorough
cleaning, the post and tube should be treated
with a light coating of machine oil to protect
the surfaces against corrosion and to ensure
smooth operation.
Installing the Tensioner
Remove the button head screw and washer
located at the end of the tensioner bar with
the 3 mm hex wrench provided. Slide the
tensioner onto the bar, being careful to align
the bar with all of the bearings and the drive
gear with the gear track. Replace the screw
and washer into the end of the tensioner bar.
Note: The tensioner bar is equipped with a
tensioner travel stop to limit travel of the
tensioner along the bar. See page 7 for more
details about this feature.
Turntable Brake
The turntable may be locked in any position.
Flip the lever up to lock the turntable brake
and flip the down to release the turntable
brake.
4