Off Hook Hot Line Dialing; Answering Calls - Yealink W52 Owner's Manual

To place a new call during an active call via the handset:
You can place at most two calls on your handset.
Press the Ext.Call soft key.
1.
The active call is placed on hold.
2. Enter the desired number in the Call To field using the keypad.
3. Press , or
NOTE:
You can also make an IP call by directly dialing the IP address of any IP phone. For example,
IP: 192.168.1.15.

Off Hook Hot Line Dialing

For security reasons, W52 Cordless Phones support off hook hotline dialing feature. When the user dials out a
call using a line with this feature enabled, the IP phone will first dial out the preconfigured number to the SIP
server the line registers to.
The SIP server may prompt the user to enter an activation code for call service. After the user enters a valid
activation code, the IP phone will use this line to dial out a call successfully. If the entered activation code is
invalid, the user cannot use this line for call service.
NOTE:
The server actions may vary on different servers.
Contact your system administrator for the activation code.
This feature is not applicable to IP call and intercom call. That is, even if Off Hook hot line dialing feature is
enabled, you can place an IP call or intercom call normally.

Answering Calls

You can answer a call in three ways:
• Using the earpiece
• Using the speakerphone
• Using the headset
NOTE:
You can ignore an incoming call by pressing the Silence soft key or reject an incoming call by
pressing the on-hook key.
You can also activate Do Not Disturb mode on a per-line basis to reject all incoming calls of the
specified line.
User Guide for the W52 Cordless Phone
to dial out.
CALL FEATURES
41