Cd Changer Controls - Audiovox Jensen Phase Linear UMP9020 Owner's Manual

UMP9020

CD CHANGER CONTROLS

Built into the UMP9020 are controls to operate
an optional CD changer. Please check with
your Phase Linear car stereo specialist or call
1-800-323-4815 for recommendations of the
models that will work with this radio.
Adjustment of the audio functions (volume,
tone, balance, and fader) and CD functions
(Pause/Play, SCN, SHF, RPT and TRACK
selection) for the CD changer operate in the
same manner as they do for radio play. See the
Operation and CD Player Operation sections
for information about these topics.
The following controls will operate the CD
changer when it is installed and connected to
this radio. Refer to the owner's manual included
with the CD changer for instructions on the
installation and correct loading and use of the
CD magazine.
CD Changer Mode Selector
7
(MODE)
Press the MODE button (7) to select operation
of the CD changer, as shown by "CDC" on the
display panel. Disc play begin and the disc and
track number are shown on the display panel. If
a new magazine has been loaded into the
changer, play begins from the first track of the
first disc in the magazine. If a magazine was
already in the changer, play resumes from the
track on the disc previously in play.
, Disc Select (CD-/CD+)
17 18
The CD-/CD+ buttons (17 and 18) are used to
select the desired disc for play. To advance to a
higher number disc, press the CD+ button (18).
To move to a lower number disc, press the CD-
button (17). The number of the disc in play is
shown on the display panel.
TAPE OPEN CLOSE CD OPEN CLOSE EJ
MUTE
SCAN
AMS
D-AUD
15
AM/FM/CD/MP3/WMACASSETTE RECEIVER
ULTRASERIES UMP9020
7
3 in 1 CD/MP3 CASSETTE RECEIVER
/
PAU SCN RPT SHF CD- CD+
13 14 15 16 17 18
WMA
7
BAND
LOUD
9
MANU
6
SKIP
8