Delayed Motor Cut-Out; Safety Cut-Out; Setting Up Location - Kranzle quadro 1200 TS Operating Manual

Delayed motor cut-out

Frequent, work-necessitated switching on and off of motors on
machines of this size puts a heavy load on the power network and
causes increased wear on internal electrical parts. Therefore the motor
of the new KRANZLE device only switches off 30 seconds after closing the gun and
then goes to stand still. By opening the gun, the device is started again.

Safety cut-out

If the device is accidentally not turned off after use or the pistol is not used for 20
minutes, the device automatically goes into the safety state via deactivating. By
operating the main switch again, the device is activated again.
Replacements and inspection work should only be performed by qualified
persons when the machine is disconnected from the power
supply, i.e. the plug pulled out from the electrical socket.
Setting up
Location
Neither set up and operate the machine in rooms where there is a risk of
fire or explosion nor put it into puddles. Do not use the machine under
water. The device must not stand in the spray area of the high pressure jet.
CAUTION !
Never suck in liquid containing solvents such as paint thinners, petrol, oil
or similar liquid matter. Pay attention to the instructions of the
manufacturers of the cleaning agents. The seals in the ma-
chine are not resistant to solvents! The spray of solvents is inflammable,
explosive and poisonous.
CAUTION !
When running your high pressure cleaner with hot water of 70° C raised
temperatures occur. Do not touch the machine without safety
gloves!
Description
7