Removing And Fitting The Appliance Door; Cleaning The Door Panels - Siemens HB34D553 Series Instruction Manual

To switch off the appliance, turn the operating mode selector
4.
back to .
Û
Descaling is complete.
Cancelling the descaling
Note: After cancelling, the appliance must be rinsed twice. The
appliance is locked against other applications until the second
rinsing operation is complete.
Press and hold the button to cancel the descaling
†
1.
process.
Nx ‹ : ...‹ min appears in the display.
To ensure that no descaling solution remains in the
appliance, it must be rinsed twice after a cancellation.
Press the † button.
2.
The symbol (Fill water tank) appears.
¯
Now proceed as described in the "Emptying the evaporator
dish and refilling the water tank" section.
Descaling the evaporator dish only
You can also use the È Descale operating mode if you do not
wish to descale the whole appliance, but only the evaporator
dish in the cooking compartment.
The only difference is as follows:
Prepare a descaling solution by mixing 100 ml water and
1.
20 ml liquid descaler.
Completely fill the evaporator dish with descaling solution.
2.
Fill the water tank with water only.
3.
Start the È Descale operating mode as described.
4.
You can also descale the evaporator dish manually.

Removing and fitting the appliance door

You can remove the appliance door to clean it more
thoroughly.
:
Risk of injury!
The hinges of the appliance door may snap shut with great
force. Always open the hinge locking lever fully when removing
the appliance door and close it fully after refitting. Do not reach
into the hinge.
:
Risk of injury!
If the appliance door has only been unhinged on one side, do
not reach into the hinge. The hinge can snap back with great
force. Call the after­sales service.
Removing the appliance door
Open the appliance door fully.
1.
Fold out the locking levers on the left and right fully (figure A).
2.
The hinges are secured and cannot snap closed.
Close the appliance door until you feel some resistance.
3.
With both hands, grip the door on the left and right-hand side,
4.
close the door a little more and pull it out (Fig. B).
$
16
%
Fitting the appliance door
Refit the appliance door after cleaning.
Insert the hinges in the left and right-hand bracket (figure C).
1.
The notch on both hinges must engage.
Open the appliance door fully.
2.
Close the locking levers on the left and right-hand side fully
3.
(figure D).
&
The appliance door is secured and can no longer be
removed.
Close the appliance door.
4.

Cleaning the door panels

To facilitate cleaning, you can remove the door panels from the
appliance door.
:
Risk of injury!
The components inside the appliance door may have sharp
edges. Take care not to cut yourself. Wear protective gloves.
:
Risk of injury!
The appliance must not be used again until the door panels
and appliance door have been correctly fitted.
Removing the door panel
Note: Before removing, make a note of the orientation in which
the door panel is fitted, so that it is not refitted the wrong way
round.
Unhook the appliance door and lay it on a soft, clean surface
1.
with the front side facing downwards (see section: Removing
and installing the appliance door).
Unscrew the cover at the top left and right of the appliance
2.
door and detach it (figure A).
Lift the door panel and remove it (figure B).
3.
$
'
%