Squeegee Cleaning - Viper AS510B User Manual

WARNING
Particular care must be taken when charging the battery because there may be
leakage of acid during the charging process. Battery acid is corrosive. If contact is
made with skin or eyes, please flush with clean water and seek medical attention.
1. Open recovery tank lid (25) and observe if recovery tank is empty or not. If it is not empty,
empty it through drain hose. (15).
2. Move the machine to a specified charging area.
3. Press the power switch (41) to the "
4. Only applicable to WET batteries:
Check the level of electrolyte inside the battery. If necessary, fill it up through the lid.
—
Keep all lids open.
—
— If necessary, clean the top surface of the battery.
5. Select one of the following procedures to charge the battery according to the model of battery
being used.
To charge a battery with an external charger
6. Confirm that the external charger is compatible. The output voltage must be DC 24V.
7. Connect the battery connector to the external charger, and connect the external charger to an
approved power outlet.
8. When charging is complete, connect the charging connector of the battery to the machine.
To charge a battery with an on-board charger (optional)
9. Remove the rubber cap at the end of the battery charging connector.
10. Connect the end of the battery charging connector with the power supply with a charge
connecting wire. (Please note whether the input voltage of on-board charger is 110V – 120V
and the output voltage 24V and frequency meet the requirements.) When the charger is
connected to the power supply, all other functions will be cut off automatically. If the red
warning light on the on-board charger continues to light, it shows that the charger is charging
the battery.
11. When the green warning light (47) is on, it shows that the battery charging process is complete.
12. When charging is complete, remove the connecting wire from the end of the battery charging
connector and the power supply, and put on the rubber cap.
13. Disconnect the charger wire from the power supply, and wind the wire on the reel (6).
NOTE
If more information on on-board charger (35) is needed, please refer to the
charger operators manual.

SQUEEGEE CLEANING

NOTE
In order to maintain the optimal squeegee performance, the squeegee must be
kept clean, and the squeegee blades must remain in good condition.
CAUTION
When cleaning the squeegee, it is recommended to put on protective gloves as
the squeegee may contain sharp debris
1. Move the machine to a flat and smooth surface.
2. Press the power switch (41) to the "
3. Unscrew the squeegee knobs (16); remove the vacuum hose from the squeegee assembly &
remove squeegee.
4. Use the squeegee lift handle (14) to lift the squeegee mount bracket.
5. Using a damp towel, clean the squeegee (Figure 15). Clean in particular the groove (A, Figure
15) and the dirt and fragments on the vacuum tube. Check if the front squeegee blade (C) and
！ ！ ！ ！
off
！ ！ ！ ！
O " position to turn off the machine.
" position to turn off the machine.
.
13
USER MANUAL