Daylight View; Still Mode; Noise Reduction; Tv-System - Panasonic PT-LB75VU Operating Instructions Manual

DAYLIGHT VIEW

You can keep the projected image bright and vivid
even in well-lit rooms where the ambient light sources
cannot be controlled, such as when a door opens or
when window coverings fail to block out sunlight.
Change setting
AUTO ON
AUTO Automatic adjustment
ON Active
OFF Deactive
Remarks
Do not cover the Ambient Luminance Sensor (
z
of the projector. The AUTO mode may not operate
normally.
AUTO is not available when INSTALLATION in
z
PROJECTOR SETUP menu is set to REAR/DESK
or REAR/CEILING.

STILL MODE

You can reduce the vertical flicker when projecting a
still image.
(Available with signals of S-VIDEO/VIDEO only)
Change setting
OFF Deactive
ON Active
Note
You must set to OFF when projecting a moving
z
image.

NOISE REDUCTION

You can switch the automatic noise reduction system
on/off.
(Available with signals of S-VIDEO/VIDEO only)
Change setting
OFF No noise reduction
ON Automatic noise reduction
Note
NOISE REDUCTION is set active when the selected
z
input signal has less noise. Applying noise reduction
may affect the image quality, if so, set to OFF.

TV-SYSTEM

When the video signal is changed, the setting
switches automatically. You can switch the setting
manually to match the video data.
(Available with signals of S-VIDEO/VIDEO only)
Change setting
OFF
SECAM
Note
z
z
ALS)
Remarks
z
RGB/YP
AUTO mode is selected by default. If the image is not
projected normally in the AUTO mode, select RGB or
YP
The function becomes effective only when certain
signals below are input.
Change setting
(VGA60, 480i, 576i, 480p, 576p, 1 080/60i, 1 080/50i,
720/60p, 720/50p)
Select the signals to be input to the COMPUTER1
and COMPUTER2 IN terminal.
Change setting
PICTURE menu
Change setting
AUTO NTSC
PAL-N
AUTO mode is selected by default.
When the projector is not working properly in
mode, change the setting according to each TV
system type.
AUTO setting will automatically select the compatible
signal from NTSC/NTSC 4.43/PAL/PAL60/PAL-M/
PAL-N/SECAM.
P
B R
P according to the input signal.
B R
Change setting
AUTO Automatic adjustment
RGB For RGB signals
YP P For YP P
B R B
Change setting
NTSC4.43
PAL-M PAL
AUTO
Change setting
signals
R
E
NGLISH - 31