White Balance R/G/B; Projecting Srgb-Compatible Pictures; Adjusting The Position - Panasonic PT-L780U Operating Instructions Manual

WHITE BALANCE R/G/B

(RGB only)
This is used to adjust the white
areas of the picture if they appear
colorised. Press the I button to
make the selected color lighter.
Press the H button to make the
selected color stronger.
Projecting sRGB-
compatible pictures
sRGB is an international color
reproduction standard (IEC61966-2-
1) established by the International
Electrotechnical Commission (IEC).
If you would like the colors in sRGB-
compatible pictures to be
reproduced more faithfully, make
the following settings.
# Press the F F or G G button to
select "PICTURE MODE", and
then use the I I or H H button to
select "NATURAL".
$ Press the F F or G G button to
select "COLOR TEMP.", and
then use the I I or H H button to
select "STANDARD".
% Select the STANDARD from the
menu screen by pressing the
F F or G G buttons and then press
the ENTER button.
& Select the LAMP POWER item
in the OPTION menu by
pressing the F F or G G buttons
and set to "HIGH" by pressing
the I I or H H buttons. (pages 44
and 45)
NOTE:
B sRGB is only enabled when RGB
signals are being input .
38
All manuals and user guides at all-guides.com
Adjusting the
When the input signal is RGB
press the AUTO SETUP butto
initiate automatic positioning.
If the optimum setting is not
obtained when AUTO SETUP
carried out, adjust by the follo
procedure.
Select the item pressing the F
buttons on the remote control
the projector.
Press the I or H buttons, to a
the alternative items. For the
numerically adjustable items, p
the ENTER button to display a
individual screen, and press th
or H buttons to adjust the sett
Some items can be adjusted
pressing the F or G buttons.
When an RGB/DVI signal is be
input
POSITION
POSITION H: 128 V:
DOT CLOCK 32
CLOCK PHASE 16
KEYSTONE H: 0 V:
TOP LEFT
OSD POSITION
RESIZING OFF ON
AUTO SETUP
FRAME LOCK OFF ON
STANDARD
SELECT:[^][@] ENTER:[ENTER]
ADJUST:[{][}] ESC:[MENU]
"POSITION", "DOT CLOCK" a
"CLOCK PHASE" are not disp
when a DVI signal is being inp
32
0