Cfd Configuration Examples - H3C S5120-EI Series Operation Manual

To do...
Display LTR information
received by a MEP
Display the information of a
remote MEP
Display the content of the LTR
that responds to LTM
messages

CFD Configuration Examples

Configuring Service Instance
Network requirements
As shown in Figure
VLAN 100. The light blue square frame and the blue one specify two different MDs.
Two MDs, MD_A (indicated by the light blue square frame, with level 5) and MD_B (indicated by
the blue square frame, with level 3)) are designed in this network.
Define the edge ports of each MD, and define the MD of each port.
The VLAN IDs of each MA in the two MDs are all 100.
According to the network diagram as shown in
configurations:
Configure MD_A on Device A and Device E
Configure MD_B on Device C
Configure MD_A and MD_B on Device B and Device D
Configure an MA in each MD
Configure a service instance for each MA
Figure 1-5 Network diagram for MD configuration
Configuration procedure
1) Configuration on Device A (configuration on Device E is the same as that on Device A)
<DeviceA> system-view
Use the command...
display cfd linktrace-reply
[ service-instance instance-id
[ mep mep-id ] ]
display cfd remote-mep
service-instance instance-id
mep mep-id
display cfd linktrace-reply
auto-detection [ size
size-value ]
1-5, there are five devices in the MDs. Each device has four ports belonging to
Figure 1-5, You should perform the following
1-10
Remarks
Available in any view
Available in any view
Available in any view