Table of Contents
Advertisement
Covers, rear removal
From the bottom, pull the rear cover (A) outward and up, removing it from the printer.
Covers, ribbon access removal
1.
Pull the gray spring-loaded ribbon access cover release latches (A), located on either side of the ribbon
access cover, up toward the front of the printer.
2.
Lift the ribbon access cover up and out of the printer.
Note: When replacing the ribbon access cover, be sure to hook the front hinge points on either side of the
ribbon access cover first, and then lower the cover into place. Be sure that both gray spring-loaded ribbon
access cover latches snap and lock.
Covers, top removal
1.
Turn the printer off and disconnect the power cord at the printer.
2.
Remove the tractor assembly, if it is installed in the pull tractor position, by pressing the locking levers and
pulling the tractor assembly out of the printer.
3.
Remove the ribbon access cover. See
4.
Remove the front cover. See
"Covers, ribbon access removal" on page
"Covers, front removal" on page
2580+, 2581+, 2590+, 2591+
4-5.
4-4.
Repair information
Previous
Next
Go Back
4-5
Advertisement
Table of Contents
