Table of Contents
Advertisement
2580+, 2581+, 2590+, 2591+
5.
Remove the rear cover. See
Note: With the option cover removed, you can see the operator panel cable attached to the logic board.
6.
Remove the two screws (A) from each side of the front cover area.
7.
Turn the printer upside down.
8.
Insert a flat-blade screwdriver into each of the four holes (B) in the bottom cover, releasing the top cover
from the bottom cover.
4-6
Service Manual
"Covers, rear removal" on page
B
4-5.
Previous
Next
Go Back
Advertisement
Table of Contents
