Table of Contents
Advertisement
Installation of input module (optional) (continued)
Connecting the signal to the dual link HD/SD-SDI input
module
•
When connecting a single link signal, connect to the LINK-A terminal.
•
When connecting a dual link signal, connect to both the LINK-A and LINK-B terminals.
Note
•
You can switch the input format mode from the SYSTEM SELECTOR menu. (pp. 56-57)
•
Settings specific to the connected device are required. (pp. 72-73)
•
To send the pictures properly, use a connecting cable with the specifications of 5CFB or higher (5CFB, 7CFB,
etc.) or of Belden1694A or higher. Also, use a cable that is shorter than 100 m.
•
Make sure that the cables used to link LINK-A terminal and LINK-B terminal are of the same type and length.
If there is a difference in length greater than 4 m between the two cables, the images will not be projected
correctly.
•
When connecting to dual link signals, connect directly to the signal output device without connecting through a
distributor or other such device. A phase difference may occur between the LINK-A signal and LINK-B signal,
which may prevent the image from being correctly projected.
•
If the connected signal is unstable, the automatic distinction function may not operate correctly. In this case,
switch to a mode that better suits the signal format from the SYSTEM SELECTOR menu.
32 – ENGLISH
Dual link HD/SD-SDI input module (optional)
ET-MD100SD4
Dual Link
HD-SDI
Module
LINK-A
ET-MD100SD4
SERIAL IN
HD-SDI or
SD-SDI signal
Business digital
VCR
LINK-B
Hide quick links:
Advertisement
Chapters
Table of Contents
