Notes When Installing The Ceiling Mount Bracket - Panasonic PT-DW100E Operating Instructions Manual

Notes when installing the ceiling mount bracket

When installing the ceiling mount bracket to the projector, install the accessory eye bolts and wires to the
projector. (The projector will still be safe if they are not used, however they will help prevent the possibility of
accidents caused by the projector falling down if the screws happen to become loose.)
Installation should be carried out by a qualified technician by following the procedure given below.
• Panasonic takes no responsibility for any losses or damage occurring as a result of using a ceiling mount
bracket not manufactured by Panasonic, or if damage to the projector occurs as a result of an inappropriate
location used for installing the ceiling mount bracket, even if the projector's warranty period has not yet expired.
• Use a torque screwdriver or similar tool to tighten the screws. Do not use tools such as electric screwdrivers or
impact screwdrivers.
• Dispose of any used products as soon as possible by asking a qualified technician for assistance.
Attention
• Be sure to use the accessory eye bolts and wires.
Installation procedure
1. Place the projector on a soft cloth
with the base facing upward.
2. Turn the four adjustable feet
counterclockwise and remove
them from the projector.
The adjustable feet will be used if the projector is
installed normally, so store them safely.
3. Turn the four eye bolts clockwise
to install them to the projector.
4. Install each of the four wires to
the four eye bolts.
5. Pull the four accessory wires from
the eye bolts to the ceiling in four
directions.
114 – ENGLISH
Adjustable feet
Eye bolt
Eye bolt
Wire