Honda 2007 Civic Hatchback Owner's Manual page 425

Vehicle Storage
FUEL HAND PRIMER
HOLDING SCREW
3. Loosen the two holding screws,
then remove the cover.
4. Squeeze the fuel hand primer until
you feel a strong resistance.
Do not press the engine cover
forcibly. This may damage the
engine cover and component parts.
422
Maintenance
5. Start the engine (see page
the engine does not start right
away, do not hold the ENGINE
START button for more than 10
seconds at a time. This will
damage the fuel pump and the
engine starter.
6. If the engine fails to start, return
to step 4.
After the engine restarts, press
7.
the accelerator pedal slightly and
hold it at approximately 1,500 rpm
for about 30 seconds. This will
complete the air bleeding in the
fuel system.
8. Reinstall the cover in front of the
fuel hand primer, then tighten the
holding screws securely.
320 ). If 9. The engine runs normally, but the
malfunction indicator lamp or the
PGM-FI warning remains on.
To turn off the indicator, restart and
turn off the engine at least three
times at intervals of approximately
30 seconds.
If this procedure is performed
during normal driving, the indicator
will be turned off and the PGM-FI
warning on the multi-information
display will go out.
If you are not sure how to bleed the
air, contact your dealer.
If the engine fails to restart after
priming the fuel system, there is a
problem in the fuel system. You
should have the vehicle inspected by
your dealer.