Toyota 2006 4runner Owner's Manual page 46

CAUTION
Avoid reclining the seatback
more than needed. The seat belts pro-
vide maximum protection in a frontal
or rear collision when the driver and
the front passenger are sitting up
straight and well back in the seats. If
you are reclined, the lap belt may
slide past your hips and apply re-
straint forces directly to the abdomen
or your neck may contact the shoul-
der belt. In the event of a frontal
collision, the more the seat is re-
clined, the greater the risk of death
or personal injury.
3. SEAT LUMBAR SUPPORT
ADJUSTING SWITCH (driver's seat
only)
Push the control switch on either side.
The amount of lumbar support will change
while the switch is pushed.
46
'06 4Runner_U (L/O 0508)
—Flattening seatbacks
(manual seat)
any
1. Remove the head restraint. Hold the
center of the lever and pull it up.
Then slide the seat further forward
than the front−most lock position.
2. Pull the seatback angle adjusting le-
ver to unlock and push down the
seatback.
When returning the seatback upright, be
careful not to make yourself hit by the
seatback which will bound with consid-
erable spring force.
After returning the seat to its original
position, be certain to replace the head
restraint.