Toyota 2006 4runner Owner's Manual page 295

—Before using the
multi−information display
Operate the multi−information display
with the ignition switch on.
When the ignition switch is turned to
"ON", the last previously used mode dis-
played just before the ignition switch is
turned off will appear.
If the electrical power source has been
disconnected from the multi−information
display, the display will automatically be
set to the initial mode.
CAUTION
Do not adjust the display while the
vehicle is moving. Be sure to adjust
the display only when the vehicle is
stopped.
'06 4Runner_U (L/O 0508)
—Clock
To reset the hour: Push the "H" button.
To reset the minutes: Push the "M" button.
If quick adjustment to a full hour is de-
sired, push the ":00" button.
For example, if the ":00" button is de-
pressed when the time is
1:01—1:29, the time will change to 1:00.
If the time is between 1:30—1:59, the
time will change to 2:00.
The key must be in the "ACC" or "ON"
position.
If the electrical power source has been
disconnected from the clock, the time dis-
play will automatically be set to 1:00 (one
o'clock).
—Outside temperature display
(air conditioning system
without "DUAL" button)
The displayed temperature ranges from
−30_C (−22_F) up to 50_C (122_F).
The key must be in the "ON" position.
If an abnormality exists in the connection
of the outside air temperature sensor,
between "−−_C" ("−−_F") will appear on the display.
If "−−_C" ("−−_F") appears on the display,
contact your Toyota dealer.
There may be a case that "−−_C" ("−−_F")
appears momentarily when the ignition is
quickly turned to "ON". It is normal if it
goes out soon.
295