wsm RC72-27B Workshop Manual page 26

RCK54-75B· RCK54/60-24B· RCK60/RC72-27B W8M, 17031
GENERAL
o
I
17030F00280
5
B A
4
Lift Bracket
1. Remove the spacer and lower links from the shaft of lower link.
2. Attach both lift brackets (3) inside the lower links (4) with the
lower link pins (1) as shown in the figure.
3. Connect the connecting rods (2) to the lift brackets (3) with clevis
pins, plain washers and cotter pins .
• IMPORTANT
• Connect the lift rods (5) of the tractor as below, and adjust
the length of both lift rods equally with the turnbuckle of the
right lift rod.
(Reference)
B7400,B7500,B2410 A Position
Tractor lift rod and lower
link setting position
B1700, B2100,
B2400, B7300, 8 Position
B2710,B2910
RCK54-75B
610mm
24.0 in.
RCK54-24B 620 mm
Connecting rod length
RCK60-24B
24.4 in.
(L)
RCK60-27B
665mm
26.2 in.
RC72-27B
670mm
26.4 in.
17030F00290
(1) Lower Link Pin
(2) Connecting Rod
(3) Lift Bracket
(4) Lower Link
(5) Lift Rod
(A) Lift rod and lower link setting
position
(8) Lift rod and lower link setting
position
17031G00150
17031F00150
Cutting Height Control Bracket (RCK54-75B)
1. Remove the clevis pin (1) from the left side lift rod (2) and
reinstall it from the inside as shown in figure.
2. Replace the left side top link holder with the cutting height control
bracket (3), using the original screw.
(1) Clevis Pin (3) Cutting Height Control Bracket
(2) Lift Rod
17031G00160
G-13