Setting Up the Reader
Setting Up the Reader
Follow the steps below to connect and get your reader up and
communicating with its host.
1.
Connect the Cable to the reader and the Host (see
"Connect/Disconnect Cable to Reader" on page 2
"Connect Host Interface" on page
2.
Configure the Interface (see
on page
3.
Configure the Reader starting on
page 5
Connect/Disconnect Cable to Reader
Figure 1. Connecting to the Reader
Side View
Host Connection —
the host device as shown in
supplied through an external power supply via the Interface
Cable supplied with a power jack.
To disconnect, insert a paper clip into the hole in the front of
the scanner, as shown:
Figure 2. Disconnecting the cable
2
6).
(optional, depends on settings needed).
The QuickScan imager plugs directly into
3).
"Configuring the Interface"
"Programming" on
Figure
3. The power can also be
and
Rear
View
QuickScan™ QD2131