Table of Contents
Advertisement
Plus 7
Plus 7 adds precision color-control channels to the HSI, HSIC, RGB, and Studio profiles. For example,
HSI with Plus 7 enabled becomes a 14-channel profile. Placing channel 7 at a value over 51% activates
the 14-channel profile within the fixture. The desired color and intensity is achieved by using the HSI or
RGB channels as a starting point. Channels 8 to 14 represent the native LED colors of the fixture and
allow you to adjust each color up or down in order to fine-tune the overall color output.
Note:
Note:
Data Channel
7
Fixture address + 6
8
Fixture address + 7
9
Fixture address + 8
10
Fixture address + 9
11
Fixture address + 10
12
Fixture address + 11
13
Fixture address + 12
14
Fixture address + 13
Color Mixes
a) See
Color Matching
The color output of all Desire fixtures is calibrated at the factory. When operating in the RGB, HSI,
HSIC, or Studio profile, each fixture makes accommodations for the specific LEDs in its array and
produces output that is consistent with other fixtures, whether or not they utilize LEDs from the same
production batch. Operating in the Direct Control profile or with Plus 7 settings adjustments bypasses
this calibration and multiple fixtures may produce slightly different outputs when controlled as a
group.
Studio Daylight, Studio Tungsten Profiles
Direct Control
The first DMX channel always controls Intensity from 0 to 100%.
Data Channel
1
Fixture address
2
Fixture address + 1
Installation and DMX Profiles
Depending on the initial color mix, some LED colors may begin at full intensity.
Moving the individual control channels for these colors from 128 to 255 (50-100%)
will produce no effective change from the initial color mix. Conversely, some LED
colors may begin at zero intensity, and moving individual control channels from 128
to 0 (50-0%) will produce no change.
When Plus 7 is enabled and the individual control channels have been adjusted, those
adjustments continue to apply after choosing a new color mix. For best results, reset
each of the individual control channels to 128 (50%) before choosing a new initial
color mix.
Control
Plus 7 control
a
Color 1
a
Color 2
a
Color 3
a
Color 4
a
Color 5
a
Color 6
a
Color 7
page
19.
on
Control
Intensity
Strobe
Value
0 to 129 = Plus 7 disabled
130 to 255 = Plus 7 enabled
128 = No change from initial color
mix
129-255 = Increase from starting
value to full intensity
127-0 = Decrease from starting
value to zero intensity
Value
0 to 255
0 to 255
Function
Disable or enable Plus 7
control
Alter the individual LED
colors within the array to a
maximum of full intensity
or a minimum of zero
intensity.
Function
Intensity 0 to 100%
Variable strobe control
21
Advertisement
Table of Contents
