Flavel Calypso FNCN**SN Series User Instructions page 12

The exact position and fit of the coals may be finely adjusted to give the most
pleasing and random appearance.
This appliance uses fuel effect pieces containing Refractory Ceramic Fibres
(R.C.F.), which are man-made vitreous silicate fibres. Excessive exposure to
these materials may cause temporary irritation to eyes, skin and respiratory
tract. Consequently, it makes sense to take care when handling these
articles to ensure that the release of dust is kept to a minimum. To ensure
that the release of fibres from these R.C.F. articles is kept to a minimum, dur-
ing installation & servicing we recommend that you use a HEPA filtered
vacuum to remove any dust and soot accumulated in and around the fire,
before and after working on the fire. When replacing these articles we
recommend that the replaced items are not broken up, but are sealed within
a heavy duty polythene bag, clearly labelled as "RCF waste". This is not
classified as "hazardous waste" and may be disposed of at a tipping site
licensed for the disposal of industrial waste. Protective clothing is not
required when handling these arrticles, but we do recommend you follow the
normal hygiene rules of not smoking, eating or drinking in the work area,
and always wash your hands before eating or drinking.
This appliance does not contain any component manufactured from
asbestos or asbestos related products.
Warning : Use only the coals supplied with the fire. When replacing the
coals remove the old coals and discard them. Fit a complete set of
coals of the correct type. Do not fit additional coals or any coals
other than a genuine replacement set.
IMPORTANT NOTE : ENSURE FIRE IS COOL BEFORE REMOVING ANY TRIM.
REMOVAL / RE-FITTING THE TRIM - RHAPSODY / CALYPSO MODELS
The trim is positioned on the firebox fixing flange and is easily replaced by
repositioning it on the fire and locating over the tabs at the top and the L/H & R/H
side retaining tabs.
REMOVAL / RE-FITTING THE TRIM - RICHMOND MODELS
The trim is positioned on the firebox fixing flange and is held in place by magnets.
REMOVAL / RE-FITTING THE TRIM - CARESS MODELS
The trim is positioned on the firebox fixing flange by locating brackets on the cast
trim. To remove lift the trim upwards slightly and then forwards. To replace, align
the brackets with the slots on the firebox and hook into place.
12