Cleaning Method; Cleaning The Pollution Sensor (Every 2 Months); Cleaning The Air Inlet And Outlet (Every 2 Months); Cleaning The Front Cover - Coway AP-1009CH User Manual

clEaNING mEthoD

- Always unplug the air purifier before cleaning the product.
- Do not use detergents that contain organic solvents (solvent, thinner, etc),
bleach, chlorine, or abrasives.
Tips
- Do not put the air purifier in water or spray water directly on it.
■

Cleaning the pollution sensor (every 2 months)

1. open the pollution sensor cover on
the right-hand side of the product.
clean the air inlet and outlet
vent and then the pollution sensor
with a soft brush or vacuum cleaner.
2. wet a cotton swab lightly and clean the lens, dust inlet,
and dust outlet. clean them with a dry cotton swab
to remove remaining moisture.
 Without regular cleaning, the performance of the pollution
sensor deteriorates.
 The cleaning cycle differs depending on the operation
environment. When using the product in a dusty environment,
clean the sensor more often.
■

Cleaning the air inlet and outlet (every 2 months)

clean the air inlet and outlet with a soft brush.
 Exercise caution not to have dust fall inside the air purifier.
■

Cleaning the front cover

separate the front cover from the product and remove the
dust attached to the surface with a soft dry brush or cloth.
 Use lightly wet cloth if the contamination is serious but do
not use abrasives.
■
Cleaning the product body (every 2 ~ 4 weeks)
clean the air inlet and outlet with a soft brush.
 Exercise caution not to have dust fall inside the air purifier.
Air outlet
▶
Dust outlet
Dust inlet
Air inlet