Cleaning Method - Coway AP-1018F Manual

CLEANING METHOD

- Always unplug the power before cleaning.
- Do not use detergents containing organic solvents (solvents, thinners,
etc.), bleach, chlorine, or abrasives to clean.
Tips
- Do not immerse the purifier in water or sprinkle water on it.
■
Cleaning the vent and
detachable vent grille
Lift the detachable vent grille on top of
the vent, then clean the grill and vent
with a soft brush or vacuum cleaner.
∗ Be careful not to let dust enter the
vent while cleaning.
■
Cleaning the air quality sensor (clean every 2
months)
1. Clean the air quality sensor air inlet and vent with a soft brush
or vacuum cleaner.
∗ Take care that dust does not fall inside the purifier while cleaning.
2. Open the air quality sensor cover on the upper rear of the
purifier. (Use the slots on the air quality sensor cover to
open it.)
Wet a cotton ball with a small amount of water
and wipe the lens, dust inlet, and outlet, then
wipe again with a dry cotton ball to
remove moisture.
∗ If cleaning is not done regularly, the air
quality sensor may not work as well.
∗ Clean more often in very dusty environments.
■
Cleaning the front cover
Remove the front cover from the purifier and then wipe away
dust
stuck to the surface with a soft, dry cloth or soft brush.
∗ If there is severe contamination, use a damp cloth (do not use
abrasives).
■
Cleaning the purifier
Wipe with a soft, dry cloth.
∗ If there is severe contamination, use a damp cloth (do not use abrasives).
▶
Vent
Air inlet
Dust
outlet
▶
Dust inlet