Gate Operator & Canadian Programming; Operating Homelink; Reprogramming A Single Homelink Button - Hyundai 2012 Santa Fe Owner's Manual

Features of your vehicle
✽ ✽ NOTICE
There are 30 seconds in which to initiate
step3.
3. Return to the vehicle and firmly press,
hold for two seconds and then release
the desired HomeLink ® button. Repeat
the "press/hold/release" sequence a
second time to complete the program-
ming. (Some devices may require you
to repeat this sequence a third time to
complete the programming.)
4. Press and hold the just-trained
HomeLink ® button and observe the red
Status Indicator LED. If the indicator
light stays on constantly, programming
is complete and your device should
activate.
5. To program the remaining
HomeLink ® buttons, follow either steps
1 through 4 above for other Rolling
Code devices or steps 2 through 5 in
Standard Programming for standard
devices.
4 36
Gate operator & Canadian program-
ming
During programming, your handheld
transmitter may automatically stop trans-
mitting. Continue to press the Integrated
HomeLink Wireless Control System but-
®
ton (note steps 2 through 4 in the
Standard Programming portion of this
document) while you press and re-press
("cycle") your handheld transmitter every
two seconds until the frequency signal
has been learned. The indicator light will
flash slowly and then rapidly after sever-
al seconds upon successful training.

Operating HomeLink

To operate, simply press and release the
programmed HomeLink
Activation will now occur for the trained
two
device (i.e. garage door opener, gate
operator, security system, entry door
lock, home/office lighting, etc.). For con-
venience, the hand-held transmitter of
the device may also be used at any time.
Reprogramming a single HomeLink
button
To program a new device to a previously
trained HomeLink
steps:
1. Press and hold the desired HomeLink
button. Do NOT release until step 4
has been completed.
2. When the indicator light begins to flash
slowly (after 20 seconds), position the
handheld transmitter 1 to 3 inches
away from the HomeLink
3. Press and hold the handheld transmit-
ter button. The HomeLink
light will flash, first slowly and then rap-
®
idly.
4. When the indicator light begins to flash
® button.
rapidly, release both buttons.
5. Press and hold the just-trained
HomeLink
Status Indicator LED. If the indicator
light stays on constantly, programming
is complete and your new device
should activate.
®
® button, follow these
®
® surface.
® indicator
® button and observe the red