Gate Operator & Canadian Programming; Operating Homelink; Reprogramming A Single Homelink; Erasing Homelink Buttons - Hyundai IONIQ ELECTRIC 2019 Manual

Gate operator & Canadian program-
ming
During programming, your handheld
transmitter may automatically stop
transmitting. Continue to press the
Integrated HomeLink ®
Control System button
steps 2 through 4 in the Standard
Programming portion of this docu-
ment) while you press and re-press
("cycle") your handheld transmitter
every two seconds until the frequen-
cy signal has been learned. The indi-
cator light will flash slowly and then
rapidly after several seconds upon
successful training.
®

Operating HomeLink

To operate, simply press and release
the programmed HomeLink
Activation will now occur for the
trained device (i.e. garage door
opener, gate operator, security sys-
tem, entry door lock, home/office
lighting, etc.). For convenience, the
hand-held transmitter of the device
may also be used at any time.
Reprogramming a single
®
HomeLink button
To program a new device to a previ-
ously trained HomeLink
low these steps:
Wireless
1. Press and hold the desired
(note
HomeLink ®
release until step 4 has been com-
pleted.
2. When the indicator light begins to
flash slowly (after 20 seconds),
position the handheld transmitter 1
to 3 inches away from the
®
HomeLink
3. Press and hold the handheld
transmitter button. The HomeLink
indicator light will flash, first slowly
and then rapidly.
4. When the indicator light begins to
® button.
flash rapidly, release both buttons.
5. Press and hold the just-trained
HomeLink ®
the red Status Indicator LED. If the
indicator light stays on constantly,
programming is complete and
your new device should activate.
Erasing HomeLink
Individual buttons cannot be erased.
However, to erase all three pro-
® button, fol- grammed buttons:
1. Press and hold the two outer
button. Do NOT
2. Release both buttons. Do not hold
The Integrated HomeLink
Control System is now in the training
(learn) mode and can be pro-
surface.
grammed at any time following the
appropriate steps in the Programming
® chapters above.
NVS
Z-Nav™ is a trademark of the Gentex
Corporation,
HomeLink
button and observe
owned
Incorporated, Milwaukee, Wisconsin.
FCC ID: NZLZTVHL3
IC: 4112A-ZTVHL3
® buttons
®
HomeLink buttons until the indi-
cator light begins to flash-after 20
seconds.
for longer than 30 seconds.
® Wireless
®
is a registered trademark and
Zeeland, Michigan.
®
is a registered trademark
by Johnson Controls,
3
3-25