Studio Videohub - Blackmagicdesign Universal Videohub 288 Installation And Operation Manual

Broadcasting device
Hide thumbs Also See for Universal Videohub 288:
Table of Contents

Advertisement

Using Videohub Routers
39 39

Studio Videohub

Studio Videohub is perfect for smaller workgroups. It features 16 SDI inputs, 32 SDI outputs, 16 bidirectional
RS-422 deck control ports, reference input, a universal power supply and powerful Videohub routing control
software for Mac OS X and Windows.
All SDI connections support auto detection of SD, HD or 3G-SDI, and reclocking on all SDI inputs.
Simultaneous routing of 2K, HD, SD video and DVB-ASI are supported with Studio Videohub.
Remote router control is performed via USB 2.0 and then shared over an IP network in much the same
way as USB printer sharing. Prior to connecting any devices to Studio Videohub, you must nominate a
computer to be the Videohub "Server" and to perform Videohub sharing via USB. You can use almost
any computer for the Videohub Server, such as an editing workstation, and you don't need a dedicated or
powerful computer for this task. However the Videohub Server computer must remain powered on at all
times so that Videohub settings can be modified. You will need to provide a standard USB 2.0 type A-B male
cable to connect Studio Videohub to the server computer.
This same USB cable can be used for applying occasional firmware updates downloaded from the
Blackmagic Design website. Programmable firmware can provide new features, compatibility with new
hardware and support for new formats. The Videohub firmware update utility runs on the Videohub Server
computer and uses the USB 2.0 connection to update Studio Videohub.
Third party router controllers can control Studio Videohub via Ethernet for router crosspoint switching. The
Videohub Ethernet protocol is documented in the Developer Information section of this manual.
Studio Videohub is 2 rack units high and less than an inch thick. You will need to leave enough space in
your equipment rack to install the Studio Videohub hardware. You can rack-mount Studio Videohub facing
forwards or reversed, or even mount it in the rear of the rack to leave space for other equipment. If you don't
have a rack, then you can leave it in a safe place on the floor!
The Studio Videohub includes a universal power supply for use in all countries. You will need to provide a
standard IEC cord with a C13 connector and a mains power socket. A second power socket will be required
if you decide to use a dedicated server computer.
If you need to learn how to integrate your router into an existing network, turn to page 7.

Advertisement

Table of Contents
loading

Table of Contents