Setting Methods; Cutting The Roll Paper - Epson SC-B6000 User Manual

SC-B6000 Series User's Guide
K
Lower the roll lock lever.
L
Following the on-screen instructions, press the
Z button.
The paper will be fed into the printer.
M
Check the media type.
The printer will display the Paper Type and Roll
Paper Remaining settings for the paper currently
selected with the printer. To print at current
settings, press the d/u buttons to highlight Keep
Settings Above and press the Z button. To
change settings, highlight Change Settings and
press the Z button. U
Changing Media Settings" on page 25

Cutting the roll paper

Either of the following two methods can be used to cut
roll paper after printing.
❏ Auto Cut:
Cut the roll paper after printing each page
automatically using the built-in cutter.
Basic Operations
"Viewing and
23
❏ Manual cut:
Press the ) button to cut the paper using the
built-in cutter. A cutline is printed for manual
cutting and can be used as a guide when cutting
paper using the built-in cutter.
Note:
❏ Disable Auto Cut when using the optional auto
take-up reel unit.
❏ It may take a while to cut the roll paper.
❏ Some of the roll paper may not be cut using the
built-in cutter. Use a cutter sold at a store to cut the
paper.
Follow the steps below when using a third-party
cutter.
Press the ) button. Keep the d button pressed to
feed the paper so that the cut location is below the
paper eject guide. Cut the paper using scissors or a
third-party cutter.

Setting methods

Use the l/r buttons in the control panel to select the /
tab and press the Z or Menu button. The Setup menu
will be displayed; select Printer Setup > Roll Paper
Setup> Auto Cut > On and press the Z button. For
manual cutting, select Off. The default setting is On.
"Setup menu" on page 47
U
Manual cut method
If Auto Cut is turned Off, you can cut at any position via
the following procedure after printing is complete.