Skoda Rapid Spaceback Owner's Manual page 114

Adjusting the ready position
Fig. 136 Remove cap from the lock / insert key into the lock
Fig. 137 Setting the ready position

Read and observe on page 111 first.
The tow bar must be set prior to installation to the standby position
» page 112, Check the setting of the standby position.
›
Grip the tow bar below the protective cap.
›
Remove the cover from the lock in the direction of the arrow
A
›
Insert the key into the lock in the direction of arrow
B
on the key symbol  shows.
›
Turn the key to the stop in the direction of arrow
B
the key symbol shows  » Fig.
›
Pull the hand wheel in the direction of the arrow
C
tion of the arrow to the stop. The hand wheel
5
position.
112
Driving
so that the arrow
2,
so that the arrow on
3,
137.
and turn in the direc-
4
remains locked in this
C
Check the setting of the standby position
Fig. 138 Ready position

Read and observe
Correctly adjusted standby position
The key is in the unlocked position - the arrow on the key points to the
A

symbol .
The locking ball

The red marking

ball bar.
There is a clear gap of approx. 4 mm

tow bar.
When in the ready position, the key cannot be removed from the lock. The ball
bar is thus set ready for installation.
» Fig. 136.
1
on page 111 first.
» Fig. 138
can be pushed fully into the tow bar.
B
on the hand wheel points to the white marking on the
C
between the hand wheel and the
D