Cleaning; To Turn The Fire Off; Ceramic Burner - Wonderfire Marseille BR622 Owner's Manual

Fireslide high efficiency fuel effect gas fire

Hide thumbs Also See for Marseille BR622:

Table of Contents

Slide the button up past the high heat position to the "O" position.

Both the main burner and the pilot should go out.

While cooling, the coals may make some crackling noises. This is quite normal.

Lighting with a taper (see figure 3)

In the unlikely event of failure of the ignition spark, the pilot can be lit by a taper or long

spill. Insert the taper or spill alongside of the left side wall of the fire box and operating

the slide control as described above.

Fig. 3 Lighting with a taper

CLEANING

Turn the fire off and allow it to cool before attempting any cleaning. Note that the fire

will retain heat for some time after it has been turned off.

If large pieces of debris are found anywhere in the fireplace, have the chimney inspected before

further use.

Metal parts

Clean the metal parts with a slightly damp cloth and then dry. Do not use abrasive cleaners,

they could scratch the surface.

Coals and burner compartment walls

This product uses a fuel effect pieces and burner compartment walls containing

Refractory Ceramic Fibres (RCF), which are man-made vitreous silicate fibres. Excessive

exposure to this material may cause temporary irritation to eyes, skin and respiratory tract.

Consequently, it makes sense to take care when handling these articles to ensure that the

release of dust is kept to a minimum.

Light coatings of soot will usually be burnt off during the normal operation of the fire.

Should any soot accumulation become excessive, the fuel effect pieces and walls should be

removed from the fire for cleaning. Cleaning should be carried out in a well ventilated

area or in the open air by gently brushing with the pieces held away from your face so that

you avoid inhaling the dust. We do not recommend the use of a normal domestic vacuum

cleaner which may blow dust back into the air. We suggest that you remove the coals in

the reverse order to that shown in the fuel bed refitting instructions.

Remove any deposits of soot or other foreign matter from the solid areas of the burner

with a dry soft brush. Be careful not to brush any particles into the open slots. Remove

any particles from the slots with a vacuum cleaner fitted with a soft brush attachment. Do

not poke wire, etc. into the slots in the burner.

Table of Contents