Cleaning Your Fire; Metal And Painted Parts; Fascia - Wonderfire 762 Installer And Owner Manual

operator. If pilot does not stay lit, repeat steps 2 through 7.
NOTE If the pilot does not stay lit after several tries, turn the gas control knob (main
valve knob) to 'OFF' and proceed to step 10.
8. Turn the 'manual' knob to the ON,
full counterclockwise
position. The main burner will now
light on the max flame setting.
9. Turn main valve knob to the full
'ON' counterclockwise
position.
10. If the appliance will not operate,
follow the instructions "To Turn Off"
below and call the Valor Fires
Technical Helpline 0844 8711 554.
To turn off.
To turn the fire off press the 'ON/OFF' switch to the 'O' (Off position).
To maintain the high performance and quality finish of your fire please follow these
guidelines:
Before attempting to clean the fire, please remember to turn off the fire and wait
for the appliance to cool completely. The fire will retain heat for some time before
cleaning can begin.
If any pieces of debris are found in the convector box, have the chimney inspected
before further use.

Metal and painted parts.

Clean the metal and painted parts with a slightly damp, lint free non-abrasive cloth
and then dry.
Do not use abrasive cleaners, as these will scratch the fire surface.

Fascia.

DO wipe any spills off immediately to limit possibility of staining.
DO clean dust down regularly with a soft, clean brush and occasionally wipe over
with a soft damp cloth.
DO NOT use abrasive cleaners.
DO NOT allow any acids or oils to come in contact with the fascia (This includes
cleaning solutions, vinegar, lemon juice, candle wax etc.).
DO NOT allow prolonged exposure to water.
©
Baxi Heating U.K. Limited 2009.
OWNER GUIDE
Figure 6. Match location

CLEANING YOUR FIRE

Page 49