Lighting With A Taper; Cleaning Your Fire; Metal Parts; Ceramic Fuel Effect Pieces And Burner Compartment Walls - Baxi 741 Owner's Manual

Lighting with a taper.

(See figure 3).
In the unlikely event of failure of the ignition spark, the pilot can be lit by a taper or
long spill.
Turn the control knob to the 'Pilot ignition' position
!
Insert the taper or spill between the second
!
and third left hand ceramic fuel effect pieces on
the first row
Depress the control knob. A flame should
!
appear at the pilot.
Remove the taper and keep the control
!
depressed for 5 seconds.
Release the control knob and the pilot flame
!
should remain alight. If it does not, repeat the
above.
Turn the control knob to the required setting.
!
While cooling, the ceramic fuel effect pieces
may make some crackling noises. This is quite
normal.
To maintain the high performance and quality finish of your fire please follow these
guidelines:
Before attempting to clean the fire, please remember to turn off the fire and wait for the
appliance to cool. The fire will retain heat for some time before cleaning can begin.
If any pieces of debris are found in the firebox, have the chimney inspected before
further use.

Metal Parts

Clean the metal parts with a slightly damp cloth and then dry.
!
Do not use abrasive cleaners as these will scratch the fire surface.
!

Ceramic fuel effect pieces and burner compartment walls.

This product uses fuel effect pieces and burner compartment walls containing
Refractory Ceramic Fibres (RCF), which are man-made vitreous silicate fibres.
Excessive exposure to this material may cause irritation to eyes, skin and
respiratory tract. Consequently, it is important to take care when handling these
articles to ensure that the release of dust is kept to a minimum.
Light coatings of soot will usually be burnt off during the normal operation of the
!
fire. Should any soot accumulation become excessive, the fuel effect pieces and walls
OWNER GUIDE

CLEANING YOUR FIRE

Page 8
Figure 3. Lighting with a taper