Advertisement
3.
Place the rear base coal in the burner compartment behind the front coal. Its
rear face should touch the rear ceramic wall (See figure 6).
4.
The ceramic side walls are marked at the rear
bottom corners "L" (Left side) & "R" (Right side). Place
the side walls against the sides of the fire box and in the
recesses at the sides of the base coals. The markings "L"
& "R" should be at the at the back bottom corners and
facing to the centre of the back of the firebox (See figure
7).
5.
Install the 7 loose
coals as follows. The
smooth surfaces of the
coals should be at the
bottom and back.
5.1.
Select the two
largest coals Place them in
the central two valleys of
the front coal (See figure
8).
5.2.
Place two of the remaining coals in the two
outer valleys of the front coal (One each side of the
large coals) (See figure 9). Place the left side coal so
that you will be able to see the pilot flame below the
coal.
5.3
Place the three remaining coals behind and approximately midway between each
of the coals in the front row (See figure 10).
Fig. 8 Front row inner coals
Fig. 7 Ceramic side walls position
Fig. 9 Front row outer coals
Fig. 6 Rear base coal position
Fig. 10 Middle row of coals
7
Advertisement
