Miele PT 7137 WP Vario Operating And Installation Instructions page 41

Problem

Power failure Programme
stopped Press OK button

Clean plinth filter

Open bottom right grille.
Clean airways

Fit plinth filter or put it in
the other way around

Drain fault Check the
drainage system.
Cause and remedy
The tumble dryer was switched off during a pro-
gramme or there has been a power cut.
 Press the OK button after switching the dryer back
on and start the programme again.
The filter is blocked or the surfaces of the fluff filters
are heavily soiled.
 Clean them as described in "Cleaning and
care". . .
. . . "Filter in the plinth"
. . . "Cleaning the fluff filters"
 Confirm with OK.
The cooling fins behind the grille can become blocked
with dust and dirt drawn in from the surrounding area
and the airways can become blocked with fluff.
 Clean as described in "Cleaning and care - Bottom
right grille/airways"
 Also check and clean the filter in the plinth and
surfaces of the fluff filters.
 Confirm with OK.
You can adjust the settings which control if or when
this message appears.
The filter in the plinth is missing or inserted incor-
rectly.
 Check the filter in the plinth.
Removing the filter during a drying programme will
result in the cancellation of the programme.
The drain hose kinked.
 Remove the kink.
 To delete the fault message: Confirm with OK.
Problem solving guide
41