Cleaning; Cleaning The Service Panel And The Heat Exchanger Housing - Miele PT 7137 WP Vario Operating And Installation Instructions

Cleaning and care

Cleaning

Tip: Fluff can be removed with a va-
cuum cleaner. This makes wet cleaning
a little easier.
 Clean the filter thoroughly under run-
ning water.
 Then squeeze it thoroughly.

It must not be replaced dripping
wet as this can cause a fault.
 Use a damp cloth to remove any fluff
from the handle
Cleaning the service panel and the
heat exchanger housing
 Use a damp cloth to remove any fluff.
Make sure that you do not damage
the rubber seal when doing this.
 Check whether the cooling fins and
the heat exchanger housing (in front
of the cooling fins) are blocked with
fluff (as follows).

Danger of injury. Do not touch
the cooling fins. You could cut your-
self.
36

Prevent damage. Carefully pass
the vacuum cleaner brush over the
surface, without applying any pres-
sure. Otherwise the cooling fins or
the struts in front of them could be-
come damaged.
Visible soiling:
 Remove any visible soiling carefully
with a vacuum cleaner using a dust-
ing brush or a narrow crevice nozzle.